⎝⎛足球正网开户⎞⎠

Dongguan Yuchen Machinery Technology Co., Ltd. Industrial dust removal equipment manufacturers provide industrial dust extraction equipment, dust collector equipment, industrial dust collector equipment, grinding dust removal equipment, polishing dust removal equipment, workshop dust removal equipment, and provide a complete set of design solutions for workshop dust treatment plant dust treatment Quotation, see on-site service
Dongguan Yuchen Industrial Dedusting Equipment Manufacturer
Provide dust removal plan for grinding and polishing dust removal equipment workshop
Unified national service hotline:
0769-81256298 400-622-6298 0769-81256298
Your location: ⎝⎛足球正网开户⎞⎠- > Industry News- > Polishing and dust removal company analyzes dust emission standardization

Polishing and dust removal company analyzes dust emission standardization


The polishing and dust removal company analyzes the excessively high filtration speed, the dust discharge rate will increase, and the excessively high filtration gas velocity will cause the initial dust layer to break, and the dust will impact the filter bag and cause excessive wear. In this case, the number of cleaning dust filter bags Too high can easily cause the fabric of the filter bag to become loose, which will cause the dust collector to exceed the standard.

When setting the pulse cleaning cycle of the dust collector, it is necessary to ensure that the dust collector works under unreasonable pressure, and the set pulse cleaning cycle time is the longest. The pulse cleaning time is to ensure that the initial dust does not fall off. The shortest time cleaning is good. If the initial dust layer is insufficient, you can use the extended cleaning cycle to compensate. If you use pressure difference control, you can improve the chaos of the inlet and outlet pressure settings of the dust collector.

If the excessive discharge of the dust collector occurs only after cleaning the filter bag, it is only necessary to check whether the pressure of the compressed air for pulse cleaning is too high.

In the operation of the dust collector, if the discharge exceeds the standard and the dust collector's operating pressure is too low than the design, it is most likely that the initial powder layer on the surface of the dust filter bag is insufficient. The reason may be that the filter bag ’s filtration speed is too high, The cleaning cycle of the bag is too short, the pressure of blowing compressed air is too high, and the load of dust is reduced.
Dust collector equipment
Dust collector equipment
Industrial dust removal equipment manufacturers_Dongguan Yuchen Machinery Technology Co., Ltd. Copyrightn 2013 Sitemap visits: [ Baidu Statistics ]
Manufacturer of dust removal equipment_Tel : 0769-8125 6298/81256299 Contact person: Miss Xie / 13922901739 Sales person of industrial dust removal equipment: Mr. Wang / 13600259680
粤ICP备13067491号-2 * Our company is a dust removal equipment manufacturer integrating scientific research, development and manufacturing. * Technical Support: Dongguan Website Construction [ Background Management ] [ Email Login ] Guangdong ICP No. 13067491-2
必赢真人娱乐 七乐彩 星力捕鱼 欢乐拼三张