Grinding, polishing and dust removal. Developed a special industrial dust collector for polishing.
Dust removal method in grinding workshop According to the characteristics of grinding dust, we have developed special industrial dust collectors for grinding and polishing, designed and installed special wind hoods, and cleaned the dust with pulse back blowing. At the same time, installing a cyclone separator can control the source of dust, form an air ring around the dust, prevent dust from overflowing, and ensure that most of the dust is sucked into the dust removal equipment, which can maximize the protection of the operator and the surrounding environment. The products are widely used in the dust removal of grinding and polishing workshops in furniture, manufacturing, castings and other industries.
Pulse dust collector refers to removing the dust attached to the filter medium (bag or filter cartridge) by blowing compressed air. Depending on the size of the dust collector, there may be several sets of pulse valves, which are controlled by the pulse controller or PLC. A set of pulse valves is used to remove the dust from the part of the bag or filter cartridge that it controls, while other bags or filter cartridges work normally. After a period of time, the next set of pulse valves opens.
The negative pressure generated by the fan enters the purifier through the side exhaust port and the lower exhaust port through the negative pressure generated by the fan, and the airflow enters the diversion channel. After the large particle dust collides with the deflector, it falls into the ash collection drawer under the action of gravity and inertia. Dust-containing gas containing fine particles enters the filter room, clean air passes through the filter core from the outer surface of the filter bag, and the dust is blocked on the surface by the filter core. When the blocked dust is continuously deposited on the surface of the filter core, it is cleaned by a manual duster structure The filter element can also be used to clean the filter cartridge by pulse spraying, so that the dust particles deposited on the filter element fall off the surface of the filter element and fall into the ash collection drawer, so that the entire surface of the filter element is cleaned. The purified air is passed through the air duct and the fan. discharge.