|Industrial dust treatment equipment series|
|Welding fume exhaust gas treatment series|
|Grinding polishing dust removal equipment|
|Stand-alone dust collector|
|Spiral duct and accessories series|
Filter cartridge dust collector equipment operation manual steps:
. 启动前准备工作 I. Preparations before starting
： 检查压力表是否接上高压气源，并 调节油水分离顺压力显示在 4-6Mpa之间。 1 : Check whether the pressure gauge is connected to a high-pressure gas source and adjust the oil-water separation pressure to be displayed between 4-6Mpa.
： 确定气包下方的放水球阀是否关闭（即未开机时，听气包是否漏气）。 2 : Determine whether the drain ball valve under the air bag is closed (that is, whether the air bag is leaking when it is not turned on).
3: Determine whether the upper and lower doors are closed.
. 启动 . 2.Start .
Turn the twisted power switch on the dust collector equipment box to the on position. When the power indicator is on, press the start button and the fan starts the machine in automatic operation.
. 关机 . Three . Shut down .
Press the stop button on the control panel, the fan running indicator goes off, then the fan stops, and finally the pulse injection stops
. 关掉 开关按扭 4. Turn off the switch button
Turn the switch button on the control panel and turn the switch button to the off position. The power indicator goes off and the device stops.
. 滤筒除尘器设备 注意事项 V. Precautions for filter cartridge dust collector equipment
1: The wire mesh in the air inlet should be taken out and cleaned once every shift;
2: Fifteen seconds after starting, the running indicator does not light up, you must shut down and restart;
3: After startup, check for abnormal sounds;
4: Check whether the air pressure of the dust collector barometer is normal and whether there is an interval exhaust sound;
5: Whether the air pressure of the air tank of the dust collector is normal, the air tank of the dust collector is drained once a day;
风机开启后，脉冲除尘器清灰控制仪方可运行 ;风机停止后，除尘 器的清灰运行 5分钟(时间可调)后关闭； 6: After the fan is turned on, the pulse dust collector cleaning controller can only run ; after the fan is stopped, the dust collector 's dust cleaning operation is turned off after 5 minutes (time is adjustable);
7: The dust removal system should be started before the production equipment is running, and the production equipment should be shut down after it stops running;
8: Every working day, the ash of the ash unloading bucket should be removed regularly (the ash unloading door can be opened and poured out manually);
每隔 20-30 天定期人工清理滤筒一次 ，或根据车间过滤面积来选择清时间。 Filter cartridge equipment manufacturers remind to regularly clean the filter cartridge manually every 20-30 days , or choose the cleaning time according to the filtering area of the workshop.