The reduction of the dust polishing and polishing dust removal load may come from the reduction of the output rate, or the inspection and adjustment of the control system of the bag filter, and the solution: You can use a light load to slowly start the loading or use the pre-dust method. To solve. Studies have shown that: too high filtration speed will increase the dust discharge rate, too high filtration gas speed will break the initial dust layer, and the dust will impact the filter bag and cause excessive wear. High can easily lead to loose fabric in the filter bag, which will cause the dust collector to exceed the standard.
When setting the pulse cleaning cycle of polishing and dust removal , it is better to ensure that the dust collector works under unreasonable pressure and the set pulse cleaning cycle time is the longest. The pulse cleaning time is to ensure that the initial dust does not fall off. The shortest time cleaning is good. If the initial dust layer is insufficient, you can use the extended cleaning cycle to compensate. If you use pressure difference control, you can improve the chaos of the inlet and outlet pressure settings of the dust collector. If the excessive discharge of the dust collector occurs only after cleaning the filter bag, it is only necessary to check whether the pressure of the compressed air for pulse cleaning is too high.