Grinding, polishing and dust removal According to the characteristics of grinding dust, we have developed special industrial dust collectors for grinding and polishing, designed and installed special wind hoods, and cleaned the dust by pulse back blowing. At the same time, installing a cyclone separator can control the source of dust, form an air ring around the dust, prevent dust from overflowing, and ensure that most of the dust is sucked into the dust removal equipment, which can maximize the protection of the operator and the surrounding environment. The products are widely used in the dust removal of grinding and polishing workshops in furniture, manufacturing, castings and other industries.
Grinding, polishing, and dust removal refers to removing the dust attached to the filter medium (bag or filter cartridge) by blowing compressed air. Depending on the size of the dust collector, there may be several sets of pulse valves controlled by a pulse controller or PLC. A set of pulse valves is used to remove the dust from the part of the bag or filter cartridge that it controls, while other bags or filter cartridges work normally. After a period of time, the next set of pulse valves opens.