⎝⎛足球正网开户⎞⎠

Dongguan Yuchen Machinery Technology Co., Ltd. Industrial dust removal equipment manufacturers provide industrial dust extraction equipment, dust collector equipment, industrial dust collector equipment, grinding dust removal equipment, polishing dust removal equipment, workshop dust removal equipment, and provide a complete set of design solutions for workshop dust treatment plant dust treatment Quotation, see on-site service
Dongguan Yuchen Industrial Dedusting Equipment Manufacturer
Provide dust removal plan for grinding and polishing dust removal equipment workshop
Unified national service hotline:
0769-81256298 400-622-6298 0769-81256298

What happened to the industrial dust collector can not start normally


When you encounter an industrial dust collector that cannot be started, you should first check whether there is any problem with the power line, including the power switch and each connection end buckle. If there is no problem, it may be a problem with the industrial dust collector. Because of its high speed, small size, and large starting torque, it can adapt to a wide range of power supply voltage fluctuations, and must use brushes and commutators. If the contact is not good, it will cause the brush or commutator to wear out too fast, or even burn out, and eventually the motor will not start, so we should detect and analyze the fault of the motor and deal with it properly. The main measures are as follows:

1. If the fuse is blown, replace it with a new one.
2. If the power cord is in poor contact or the motor leads are loose, the power source should be connected.
3. If the power switch is damaged, replace the power switch.
4. If the motor is damaged, replace it with a new one.

Industrial dust collectors have cleaned our environment and produced fewer occupational diseases. Its power is indispensable. However, due to the high power of industrial dust collectors and the high frequency of use, it is inevitable that some faults will occur during use. What causes the industrial dust collectors to malfunction? Today I will help you analyze it.

1. The noise is too large: it may be caused by severe bearing wear, deformation or displacement of the impeller shaft, loose fasteners, wear of the motor, loose or damaged fan blades, etc.

2. Decreased suction: It is caused by the failure of the motor, the wear of the brushes, the dampness of the dust filter, the clogging of the hose and the dust suction or exhaust port, the dust collection room full of dust, and the poor interface seal.

3. The case is charged: This is caused by the aging of the power cord, which causes ground leakage and the internal circuit of the vacuum cleaner to contact the case.

4. Fuse connection blowout: It is caused by short circuit of power cord, plug, socket, short circuit of motor coil, short circuit of internal wiring of vacuum cleaner.

5, motor overheating: caused by continuous working time is too long, brushes and commutator wear sparks are too large, dust room is full of dust, dust on the filter is too much.
Dust collector equipment
Dust collector equipment
Industrial dust removal equipment manufacturers_Dongguan Yuchen Machinery Technology Co., Ltd. Copyrightn 2013 Sitemap visits: [ Baidu Statistics ]
Manufacturer of dust removal equipment_Tel : 0769-8125 6298/81256299 Contact person: Miss Xie / 13922901739 Sales person of industrial dust removal equipment: Mr. Wang / 13600259680
粤ICP备13067491号-2 * Our company is a dust removal equipment manufacturer integrating scientific research, development and manufacturing. * Technical Support: Dongguan Website Construction [ Background Management ] [ Email Login ] Guangdong ICP No. 13067491-2
必赢真人娱乐 七乐彩 星力捕鱼 欢乐拼三张