The capacity of industrial dust collectors
is larger than that of commercial and domestic vacuum cleaners. Considering large-capacity waste and dirt, cleaning industrial vacuum cleaners are planned, and the capacity and movement of the capacity cylinders are very convenient. It may be different depending on the situation. The waste box may be a recovery box to deal with industrial vacuuming. The most common problem is the intervention of the front device, which can increase the capacity and separate the recovered materials from different materials. Can compensate for some shortcomings of industrial vacuum cleaners of different plans.
When the industrial dust collector fails to start, you should first check whether there is any problem with the power supply line, including the power switch and each connection end buckle. If there is no problem, it may be a problem with the industrial dust collector. Because of its high speed, small size, and large starting torque, it can adapt to a wide range of power supply voltage fluctuations, and must use brushes and commutators. If the contact is not good, it will cause the brush or commutator to wear out too fast, or even burn out, and eventually the motor will not start, so we should detect and analyze the fault of the motor and deal with it properly.
The main measures are as follows:
1. The industrial dust collector
is blown out. Replace the fuse with a new one.
2. If the power cord is in poor contact or the motor leads are loose, the power source should be connected.
3. If the power switch is damaged, replace the power switch.
4. If the motor is damaged, replace it with a new one.