塑料,铝业,治金,五金,重工及机械加工等领域。 Bag dust collectors are widely used in such fields as casting , plastics , aluminum , metallurgy , hardware , heavy industry and machining. Through investigation and research, a serious problem exists in industrial dust collectors. 的维护与保养没有足够的重示，从而导致布袋除尘器寿命降低.现在由宇晨工业除尘厂家为大家介绍布袋除尘器的日常维护及保养 ： It is that the maintenance and maintenance of the dust collector is not repeated enough in daily work, which leads to the reduction of the life of the bag dust collector . Now Yuchen Industrial Dust Factory introduces the daily maintenance and maintenance of the bag dust collector :
When the bag filter needs maintenance and warranty, the staff should cut off the power supply and air source, and keep the air bag under normal pressure. 应当把里面的粉尘清理干净，并静置后反复清理，确保里面无粉尘，照明设置时禁止用明火。 When performing internal maintenance on the dust collector , the dust inside should be cleaned up and cleaned repeatedly after standing to ensure that there is no dust inside. It is forbidden to use open flames when setting lighting. Fire extinguishers should be installed on site to prevent dust explosions.
1. Establish a regular maintenance system so that problems can be found in time to avoid major accidents.
2. It is forbidden to stack flammable and explosive items around the dust collector, and the ventilation is good.
3. The staff should regularly check the sealing status of the dust collector and the running status of the wind network (including the fan).
，如果破损要及时更换，对备用除尘布袋的存放也要注意干燥、通风防尘，并要定期检查。 4. Regularly check the dust bag . If it is damaged, replace it in time. Pay attention to the dry, ventilated and dust-proof storage of the spare dust bag, and check it regularly.
5. Regularly clean up impurities and water in the air source processor.
6. Regularly refuel the transmission. Be sure to pay attention to the dust after the refueling, and be sure to install a gasket when closing the inspection port.
7. Keep the pulse controller and solenoid valve clean and free of dust and oil. Check the control coil on the solenoid valve regularly.
8. The dust layer on the surface of equipment and duct should be cleaned immediately.