也一定要做好设备的维护工作,只有这样才能保障机器更好的正常运行。 When manufacturing enterprises use industrial dust collectors , they must also do a good job of equipment maintenance . Only in this way can the machines run better. The troubleshooting of industrial dust collector mainly includes the following points. Next, Yuchen Industrial dust removal manufacturers will briefly introduce it for everyone.
、电机的保险丝连接熔断形成原因:电源线、插头、座短路、电动机线圈短路、除尘器内部连线短路。 1. The cause of the fuse connection of the motor is blown : the power cord, plug, socket is short-circuited, the motor coil is short-circuited, and the internal wiring of the dust collector is short-circuited.
、机壳带电形成原因:电源线老化,因而对地漏电、除尘器内部线路与机壳接触. 2.The reason for the formation of the cabinet's electrification : the power cord is aging , so the ground leakage, the internal circuit of the dust collector is in contact with the cabinet .
、噪音大引起的原因:轴承磨损严重、转轴弯曲、叶轮轴变形或移位、紧固件松动、电动机磨损、风扇叶松动或损坏等因素引起。 3. Causes caused by large noise : serious bearing wear, bending of the rotating shaft, deformation or displacement of the impeller shaft, loose fasteners, wear of the motor, loose or damaged fan blades, etc.
、吸力下降引起的原因:电动机本身出故障、电刷磨损、除尘器受潮、集尘室满尘、软管及吸尘口或排气口堵塞、管路漏气、接口密封不良等。 4. Reasons for the decrease in suction : The motor itself is faulty, the brushes are worn, the dust collector is wet, the dust room is full of dust, the hoses and the suction or exhaust ports are blocked, the pipes are leaking, and the interfaces are not well sealed.
、电机过热引起的原因:工业除尘器连续工作时间太长、电刷和整流子磨损产生火花过大、滤尘器上粘灰太多、集尘室满灰等。 5. Causes caused by overheating of the motor : the continuous working time of the industrial dust collector is too long, the sparks generated by the wear of the brush and commutator are too large, the dust on the dust filter is too much, and the dust collection room is full of dust.
粒径与分散度、密度与堆积密度、凝聚性、湿润性、荷电与导电性、自然堆积角、爆炸性等因素来设计。 Industrial dust collectors mainly use AC power sources , which have
large power , and
are usually divided into two types: mobile and fixed .
The multi-phase mixture involved in industrial dust removal is called gas suspension or aerosol .
The fine particles dispersed in it are called dust particles. Or particles ,
and the accumulation state of dust particles is called powder .
In engineering design, in order to more accurately design and select the dust removal equipment , the
engineering designer must be sure to master the main physical and chemical properties of the dust, and the parameters used to describe the dust properties There are :
particle size and dispersion, density and bulk density, cohesiveness, wettability, charge and conductivity, natural packing angle, explosiveness and other factors to design.