|Industrial dust treatment equipment series|
|Welding fume exhaust gas treatment series|
|Grinding polishing dust removal equipment|
|Stand-alone dust collector|
|Spiral duct and accessories series|
Woodworking dust removal equipment occasionally has some large and small failures during use. How to check and deal with the failure?
： 木工除尘设备马达电机发热，电机发热原因可以是周围环境的温度太高导致，解决方法改善周围通风，或加冷却设备。 1 : The motor of the woodworking dust removal equipment is hot. The motor may be caused by the surrounding temperature being too high. The solution is to improve the surrounding ventilation or add cooling equipment.
：设备电气柜发生故障，应该检查冷确空调是否在正常运行，是否雪种用完了没有用时补充，还有排风扇是否在正常旋转，如果没有正常旋转，应该及时更换新的排风扇，确保通风顺畅！ 2 : The electrical cabinet of the equipment is malfunctioning. It should be checked whether the cold air conditioner is operating normally, whether the snow is used up and not replenished, and whether the exhaust fan is rotating normally. If it does not rotate normally, the new exhaust fan should be replaced in time to ensure smooth ventilation !!
：除尘器的吸力效果下降，检查吸尘管道是否有破损情况，管道连接处螺丝是否有松弛的现象，这二种情况可以自备玻璃胶，除尘器设备停机后在漏风处打上玻璃胶，等胶干了，在开机运行！ 3 : The suction effect of the dust collector is reduced. Check whether the suction pipe is damaged and whether the screws at the joints of the pipe are loose. These two cases can be provided with glass glue. After the dust collector equipment is shut down, apply glass glue. Wait for the glue to dry and run at boot!
：除尘器设备出现漏灰情况，检查除尘滤袋或除尘滤筒是不是用的太久老化了，表面是否被粉尘堵塞等，如果出现这种情况，可以找除尘器厂家来更换新的除尘滤袋或除尘滤筒。 4 : Dust leakage occurs in the dust collector equipment, check whether the dust removal filter bag or dust filter cartridge has been used for too long, and whether the surface is blocked by dust. If this happens, you can ask the dust collector manufacturer to replace the dust collector with a new one. Filter bag or dust filter cartridge.