|Industrial dust treatment equipment series|
|Welding fume exhaust gas treatment series|
|Grinding polishing dust removal equipment|
|Stand-alone dust collector|
|Spiral duct and accessories series|
The electrostatic precipitator has the following characteristics:
、轧制收尘极尺寸精度高，采用计算机全套设计，设计准确可靠。 1. The rolling dust collector has high dimensional accuracy, and adopts a full set of computer design, which is accurate and reliable.
、振打器在除尘设备顶盖上，电除尘设备内完全没有活动件，基本上不必进入检修，维护工作全在外部。 2. The vibrator is on the top cover of the dedusting equipment. There are no moving parts in the dedusting equipment. Basically, there is no need to go to maintenance. The maintenance work is all external. The vibration force of the electromagnetic mallet can be adjusted by changing the electromagnetic pulse, and the matrix control vibration system is flexible and convenient.
、运行稳定，不结露，不爬电，故障率极低； 3 , stable operation, no condensation, no creepage, extremely low failure rate;
、对于其它工业粉尘，同样可用本除尘设备治理，还可进行水泥及其它有实用价值的粉尘进行回收。 4. For other industrial dust, this dust removal equipment can also be used for treatment, and cement and other practical dust can be recycled.
、供电及控制采用微机控制供电，振打控制设备采用 PLC 控制，灵活、可调、可靠。 5. The power supply and control adopts microcomputer control power supply, and the vibration control equipment adopts PLC control, which is flexible, adjustable and reliable.
、放电系统绝缘器件全部在顶室之内并有热风吹扫，工作条件比一般电除尘设备更好。 6. The insulation components of the discharge system are all in the top chamber and are blown by hot air. The working conditions are better than that of general electric dust removal equipment.
、可以小分区供电，即将一个电场在电气上分为两个部分，各用一台高压电源供电，可在同样规格的电除尘设备上，获得更高的除尘效率。 7. It can supply power in a small area, that is, an electric field is electrically divided into two parts, each of which is powered by a high-voltage power supply. It can achieve higher dust removal efficiency on the same type of electric dust removal equipment.
Our electrostatic dedusting equipment filter has the following characteristics:
Suitable for powder spraying, sand blasting operation, pigment industry, wood processing filtration, imported long-fiber polyacetate filter material, the fibers are staggered with each other, uniformly distributed, and abrasion resistance is better than the traditional filter material can withstand the pulsed air blow The filter material has good stiffness and can be repeatedly cleaned. The end cap and the central skeleton are all electro-galvanized parts. It is non-rusty. It is a special sealed closed-cell elastic neoprene rubber. It can be washed with water and can be used repeatedly.
The surface is covered with a thin layer of conductive aluminum foil fiber, and the base material is a polyester fiber or carbon fiber blend, which is anti-static while ensuring the abrasion resistance and filtering effect of the filter cartridge. Each filter cartridge is provided with a special ground wire to prevent the static electricity generated by dust friction from accumulating in the dust collector to generate dust electrostatic explosion.
Working principle of electrostatic precipitator:
After entering the equipment with dust gas from the air inlet on the top of the equipment, it passes through the cyclone separator at high speed, so that the dust-containing gas is adjusted to rotate downward along the axis, and the centrifugal force is used to remove the coarse particles of dust, which effectively controls the entry of the electric field. Initial dust concentration. Then, the gas enters the electric field through the lower ash hopper. Since the lower ash hopper cross-sectional area is several times larger than the inner tube cross-section, according to the principle of constant rotation moment, the radial wind speed and axial wind speed are sharply reduced to produce a zero-speed interface, which makes the inner tube The heavy particles of dust settle in the lower ash hopper, which reduces the dust concentration entering the electric field. The low-concentration dust-containing gas is condensed on the cathode and anode plates by electric dust collection, and the collected dust is discharged by the air lock after being shaken by dust cleaning. The ash device is transported away.
Related content: Precautions for using electrostatic precipitator
厂家会设计卸灰、振打装置，让粉尘更流畅的排出来！ When the dust falls in the ash bucket of the electrostatic dedusting equipment, the dust is generally discharged from the ash bucket by the ash conveying and discharging device. Generally, in order to allow the dust to be discharged smoothly, the dust removal equipment manufacturers will design ash discharge and vibration devices to allow the dust Smoother discharge!