|Industrial dust treatment equipment series|
|Welding fume exhaust gas treatment series|
|Grinding polishing dust removal equipment|
|Stand-alone dust collector|
|Spiral duct and accessories series|
Troubleshooting methods for bag dust removal equipment:
If the dust removal equipment fails to start, you should check the power circuit for problems, including the power switch and the motor control part. If there is no problem, the motor of the dust removal equipment may be burned out. Due to the large equipment, high fan speed, small size, and large starting torque, considering the starting angle of the fan when the fan is needed, this situation of fewer motors will be avoided.
主要措施如下: The main measures for troubleshooting methods of bag dust removal equipment are as follows:
1. Fuse the dust removal equipment and replace it with a new one.
2. If the power switch is damaged, replace the power switch.
3. If the motor is damaged, replace it with a new one.
4. If the power cord is in poor contact or the motor leads are loose, reconnect the leads and secure them.
If you encounter a bag filter with excessive resistance or poor ventilation, you will encounter the following problems:
(1) The compressed air pressure is far lower than the rated value of the working pressure of the dust collector.
(2) The ash discharge valve has poor air lock and air leakage.
如下: The troubleshooting method of bag dust removal equipment is as follows:
(1) Adjust the appropriate compressed air pressure.
(2) Stop the ash discharge valve immediately or replace it with a new product.
The reason why the electromagnetic pulse valve is normally closed:
(1) The controller is damaged.
(2) The solenoid valve is faulty or the vent is blocked.
(3) The film is damaged.
Troubleshooting methods for bag dust removal equipment :
(1) Replace the controller.
(2) Repair or replace the solenoid valve.
(3) Replace the diaphragm.
Reasons for solenoid pulse valve always open:
(1) The solenoid valve cannot be closed.
(2) The small hole is completely blocked.
(3) The gasket on the diaphragm loosens and leaks, repair or replace the solenoid valve, remove the dirt on the orifice, reinstall the pulse valve, install the gasket, and replace the failed spring.
主要生产除尘器、除尘设备、除尘配件等产品. 布袋除尘设备故障排除方法更多有关产品的更多信息，请访问我们的官方网站！ Yuchen dust removal equipment manufacturers mainly produce dust collectors, dust removal equipment, dust removal accessories and other products. Troubleshooting methods for bag dust removal equipment . For more information about our products, please visit our official website!