|Industrial dust treatment equipment series|
|Welding fume exhaust gas treatment series|
|Grinding polishing dust removal equipment|
|Stand-alone dust collector|
|Spiral duct and accessories series|
Bag dust collector maintenance : Equipped with water sprayer to ensure good atomization. One quarter of an hour before grinding to avoid the effect of delayed water evaporation on the filter bag. The air pressure of the bag filter is maintained at 0.5 MPa, which is separated from water and oil, and the time that the airbag should be released. Check the air passage inside the bag filter and control the purge air to check the filter bag for blockage. If there is a slight blockage, drain it and pat it clean. Make sure to maintain ventilation and prevent the blockage from continuing to form a vicious cycle.
Regularly check the leakage of the exhaust gas treatment system, completely block it, and conduct necessary external insulation for the exhaust gas system. Cold milling in low temperature season, try to prevent too much moisture from entering the mill during temperature rise; pay attention to controlling the feed rate; circulating mill can increase the amount of powder to increase the temperature of the internal air. Before stopping coal milling, the extraction time should be extended as much as possible, and the mixture with high water content should be stopped in advance. After stopping the milling, the discharge time should be appropriately extended to transfer the grinding body.
Precautions for operation: Before starting the dust collector in each shift, check the oil level of the unloading device of the centrifugal fan and the oil level of the fan bearing box. Check that the duct air valve is in the set switch position. Check that the position of the pulse controller knob is appropriate. Start the vacuum cleaner before starting the grinding wheel. Restart the grinder and turn on the pulse controller to start working.
When the dust collector is running, the discharge device before each shift discharges for 5-10 minutes. The gray pipe near the belt needs to be connected to a soft cloth tube so that the dust can slowly flow on the belt to prevent secondary dust. The electric valve hands open at 900 and the hands close at 00. There are two types of manual valves: clockwise and counterclockwise.
The left knob of the pulse controller controls the opening of the blower solenoid valve. Left hand small right hand large ... The right hand key controls the pulse backflush time. The left hand is short and the right hand is long. It is usually adjusted for about one minute. The positions of the two knobs are located at about 450 on the right hand side. It is the responsibility of the grinder driver to use and maintain the dust collector. Keep a record of the vacuum cleaner.
提供的袋式除尘器维护相关介绍，更多相关推荐： 如何选择合适的袋式除尘器? The above is the introduction of bag dust collector maintenance provided by Yuchen dust removal equipment manufacturers . More related recommendations: How to choose the right bag dust collector?